Texa V Manufacturer

TEXA V Manufacturer The IDC3 Software used by the Texa Diagnostic equipment, is for use on multi-makes and multi-systems. I'm doubtful that its features regarding a particular make of vehicle would be comparable to the OEM dealer tool. However the advantages of the IDC3 software are its width of coverage rather than depth. The table below compares the functions of the IDC3 with those of OEM dealer tools supplied to the INDEPENDENT repairer, which are usually restricted by the manufacturer. *The depth of functions for each manufacturer that the IDC3 covers may not be as comprehensive as the OEM tool.

1.3.1

1.3.2

1.3.3

1.3.4

1.3.5 1.3.6

Poss. for independent repairer to update software/ re-programme Can independent repairer carry out variant coding Can independent repairer carry out initialisation/reinit. Can independent repairer carry out pass-through programme. Can independent repairer reset security systems Covered by Texa IDC3*

DAF

IVECO

VOLVO

SCANIA

Renault Trucks

MAN

MercedesBenz

Texa IDC3*

no

yes

no

no

no

no

yes

no

no

yes

yes

yes

no

no

yes

yes

no

yes

yes

no

no

no

yes

yes

no

no

yes

no

no

no

no

no

no

no

no

no

no

no

no

no

yes

yes

yes

yes

yes

yes

yes

yes

*Functionality may vary depending on make, model and system Points to mention: 1. Function checks are available with the IDC3, but again are dependent on the make & model. Safety levels are high with the IDC3 (possibly due to Italian law), there is a special code to unlock certain programming/settings functions on safety and security related systems. 2. Fault diagnosis is the job of the technician the IDC3 software and hardware are tools to aid diagnosis by providing as much information as possible. This includes fault code and live data acquisition, wiring diagrams, internet search facility, technical bulletins, actuator tests, oscilloscope mode (extra module required), telephone helpline to name a few. 3. All popular manufacturers are covered, functions are dependent on model and system. 4. Only certain parameters are programmable. Again this is dependent on make and model. I hope the information above helps to show the coverage and detail of the Texa IDC3 diagnostic software and hardware.

Fleet Parts Ltd New Cut Ind Est, New Cut Lane, Woolston, Warrington. WA1 4AG Tel: 01925 824019 Fax: 01925 817340 Contact: Mark Erskine: Mob 07711172436 Email: [email protected]