Eoc 1.docx

POLITEKNIK TUANKU SYED SIRAJUDDIN DEJ5153 – PLC & AUTOMATION END OF CHAPTER NAME :

CLO/GSA MARKS CLO1 CLO2 TOTAL

MATRIX NO:

/16 /34 /50

1. Give an example of Function Block diagram and sequential Function Chart programming solution for a system. You can choose any system and state its function. [CLO1,C2 4 marks] 2. List THREE logical sensors and its functions.

[CLO1,C1 6 marks]

3. Write the mnemonic codes for the following ladder diagram

[CLO2,C3 13 marks]

INSTRUCTION

4. Draw the ladder diagram for the following mnemonic code

ADDRESS 00000 00001 00002 00003 00004 00005 00006 00007 00008 00009 00010 00011 00012 00013

INSTRUCTION LD AND LD AND OR LD OR AND AND NOT LD AND OR AND LD OUT FUN(01)

Prepared By

(Shamsul Anuar Bin Abd Aziz) DEJ5153 Coordinator

DATA/OPERAND

[CLO2,C3 13 marks]

DATA 00003 00002 00006 00007 00008 00001 00000 00004 00005 00009 10000 Approved By

( ) Head of Programme/Head of Department

5. Design the ladder diagram for the application problem provided.

[CLO2,C5 14 marks]

Automatic Control of Warehouse Door When Sensor in detected the incoming truck, the barrier will raise and stop at it position when it touched upper limit switch. After the truck has passed by the barrier, the barrier will be go down until it touched the lower limit switch.

i.

Prepare input/output assignment Input

Prepared By

(Shamsul Anuar Bin Abd Aziz) DEJ5153 Coordinator

Devices

[CLO2,C3 6 marks] Output

Devices

Approved By

( ) Head of Programme/Head of Department