Print Form 08-06
For Residential, Light Commercial, and Snowmelt Applications Job Name –––––––––––––––––––––––––––––––––––––––––––
Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location –––––––––––––––––––––––––––––––––––––––––
Approval
Engineer –––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval –––––––––––––––––––––––––––––––––––––––––––––
Representative
–––––––––––––––––––––––––––––––––––––––––––––
––––––––––––––––––––––––––––––––––––––––
HydroNex DHX Panel Sizes: 1-1/4" Trunk; 1-1/4" Zone DHX panels use injection mixing to modulate the supply fluid temperature to the radiant or snowmelt zone. A heat exchanger is used to isolate system fluid from the zone fluid. Both the injection bridge and the zone supply piping is 1-1/4". A Tekmar 361 can be selected for heating applications or a Tekmar 665 may be selected for snowmelt applications. Both have the ability to operate with reset (injection) or set point temperature control.
Installation Make sure an electrical outlet is within 3 feet of where the D-Series panel will mount. If there are no outlets, one will need to be added. Install and level Z-Bracket with 1/4” x 2-1/2” lag screw to studs. Make sure the Z-Bracket is the correct size for the given D-Series panel. Incorrect Z-Brackets may interfere with cover placement. Hang the D-Series panel on the Z-Bracket. Lag screws should be added to the bottom of the panel, further securing the panel to the wall. Hang cover from top down. To purge a DHX panel make sure all necessary isolation valves are closed and all purge valves are open. Proceed until all zones are filled and purged. Open all purge ball valves and cap the drain. Make sure all isolation ball valves are open for normal operation. Both sides of the heat exchanger will require seperate purging. Refer to the installation manual for further details.
Features – Wall mounted white powder coated back panel and cover. – Easy access to all components. – Pre-wired circulators and controls. – Simple CAT 5 jump wiring to connect panels. – Single union connection between panels. – Integrated leveling system. – Z-Bracket for simplified mounting.
Specifications Supply Voltage . . . . . . . . . . . . . . 120 Volts Circulator Type. . . . . . . . . . . . . . . Watts Radiant* . . . . . . . . . . . . . . . . . . . . . . Taco . . . . . . . . . . . . . . . . . . . . . . Bell and Gossett Heat Exchanger. . . . . . . . . . . . . . 150 MBH . . . . . . . . . . . . . . . . . . . . . . 250 MBH Electrical . . . . . . . . . . . . . . . . . . . Relay and CAT 5 Connection Injection/Reset Control . . . . . . . . Tekmar 361 . . . . . . . . . . . . . . . . . . . . . . Tekmar 665 *Panels with Watts Radiant circulators are available in 150 MBH only.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements, please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials without prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
Hydronex DXH panel. General mounting method.
JUMPER T/R AND T/W
JUMPER T/R AND T/W
BLUE
WHITE BLUE
4
5
Do not apply power
RESET OVERRIDE
MODE
RED
T-STAT
RESET T/R T/W COM
UP
1 2
Blu
Red Blk
Com Brn/ Yel SlabOut tN2
9 10 11 12
TAB
13 14 15 16 17
Melt/Idle Heat Demand
7
8 NORMAL
1 2 3 4 5 6 7 8
WHITE
BLUE
WHITE
GREEN
EXPANSION
MASTER
SLAVE
1
WHITE BROWN
ORANGE
WHITE ORANGE
GREEN
WHITE GREEN
BLUE
WHITE BLUE
4
5
6
Melting Sys Power P1 L N
2
BROWN
3
GREEN
RED
3
1 WHITE ORANGE
RED
6
2 ORANGE
WHITE
GREEN
WHITE GREEN
GREEN
WHITE BROWN
WHITE
SLAVE
7
BROWN
X X 1 2 3 4
665
TAB
8 NORMAL
11 12 13 14 15 16 17
RED END SWITCH
UP
1 2
BLUE
RED
MODE RESET
WHITE
RESET OVERRIDE
UnOComBoil Mix ComOut Indr Sw
BLACK GREEN
WHITE
BLACK
BLACK
N H ZC ZR H H SR 501-EXP
GREEN
P1
WHITE
P2 WHITE
WHITE
BLACK
CIRC. PRIORITY OUTPUT OUTPUT
RED
120VAC OUTPUT
GREEN
120VAC INPUT
BLACK
POWER INPUT
WHITE
WHITE
SMALL BUCHANAN (TYP)
GREEN
SR 501-EXP
BLACK
N H ZC ZR H H BOILER RETURN SNSR.
INJ P1
BLACK
MIX TEMP. SENSOR
WHITE
WHITE
Boiler
RED
WHITE
WHITE
BLACK
BLACK
BLACK
BLACK
WHITE
Mix Power Sys Var Pmp N Pmp N Demand L N
T-STAT T/R T/W COM
MASTER
BLUE
9 10
EXPANSION
X X 1 2 3 4
Do not apply power 1 2 3 4 5 6 7 8
BLUE
RED END SWITCH
361
Switch must be set to Normal Switch must be set to Slave
GREEN
Switch must be set to Slave
WHITE
Switch must be set to Normal
GROUND SCREW
POWER INPUT
120VAC INPUT
120VAC OUTPUT
CIRC. PRIORITY OUTPUT OUTPUT
WHITE WHITE BLACK
BLACK GREEN
14/3 WIRE
18/3 SJ WIRE TO CIRCULATORS
SMALL BUCHANAN
18/3 WIRE TO CIRCULATORS
18/2 T-STAT WIRE
GROUND SCREW
18/3 SJ WIRE
Hydronex DXH with a Tekmar 361 control.
Hydronex DXH with a Tekmar 665 control.
Qty Description
Part #
Order #
P an el Siz e
DHX Panel, 150 MBH with Watts Radiant Circulators, Tekmar 361
DHXS150-1WRT361
81009270
M
DHX Panel, 150 MBH with Taco Circulators, Tekmar 361
DHXS150-1TAT361
81009272
M
DHX Panel, 250 MBH with Taco Circulators, Tekmar 361
DHXS250-1TAT361
81009273
M
DHX Panel, 150 MBH with B&G Circulators, Tekmar 361
DHXS150-1BGT361
81009274
M
DHX Panel, 250 MBH with B&G Circulators, Tekmar 361
DHXS250-1BGT361
81009275
M
DHX Panel, 150 MBH with Watts Radiant Circulators, Tekmar 665
DHXS150-1WRT665
81009276
M
DHX Panel, 150 MBH with Taco Circulators, Tekmar 665
DHXS150-1TAT665
81009278
M
DHX Panel, 250 MBH with Taco Circulators, Tekmar 665
DHXS250-1TAT665
81009279
M
DHX Panel, 150 MBH with B&G Circulators, Tekmar 665
DHXS150-1BGT665
81009280
M
DHX Panel, 250 MBH with B&G Circulators, Tekmar 665
DHXS250-1BGT665
81009281
M
USA: 4500 East Progress Place, Springfield, MO 65803; www.wattsradiant.com Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca
08-06 Effective Date: June 2008
© Watts Radiant, 2008