Solutions for Mobile Spectrum Monitoring Systems
(Placeholder for a cover picture; this picture should always touch the blue border line as shown here)
Software Main Tasks • Investigations of interference due to cochannel emissions, out-of-channel emissions and intermodulation • Monitoring of technical transmitter parameters (short-term, long-term, deviation measurements of FM broadcast transmitters) • Field strength measurements • Identification of unlicensed stations • Frequency occupancy measurements • Planning and management of transmitters
Software Measurement of technical parameters
Standard technical parameters can easily be measured and the results displayed in dialog windows, tables and graphics. Typical parameters are Level, Frequency, Bit rates, BER, MER, … All results can be saved in a database for later evaluation and analysis.
Software Measurement of technical parameters
Software Measurement of technical parameters Example of a transport stream analysis
Software Measurement of technical parameters Example of a graphical displays
Software There are 3 different ways to perform these measurements:
Interactively Automatically Guided
Interactively Operator defines task, measurement starts immediately and the results are displayed (table and graphics). Operator can check results and react accordingly. Automatically Operator defines measurement tasks and time slot(s), measurement will start and stop automatically without any further user intervention. In case of remote control connection can be closed. Guided Operator is guided step by step, only equipment which can perform the specific tasks is shown, default values are given (e.g. depending on the selected frequency or modulation type), indication, if selected parameters are not compliant with respective ITU recommendation.
Hardware of R&S ARGUS-FMTV
♦ Compass and GPS receiver for determining vehicle direction and location ♦ System process controller with Monitoring Software R&S ARGUS and Geographic Information Software R&S MapView for system operation ♦ Printer to output lists and results
Project Bhutan •Mobile Monitoring System •based on Toyota Landcruiser •with tropical specifications System integration using mostly existing vehicle interiour Tiltable mast for antenna installtion First integration of EB200 Right-hand driven
Project Bhutan
Project Tanzania •Mobile Monitoring System •based on Toyota Landcruiser •with tropical specifications Tiltable mast for antenna installation electrically operated HF/VHF Communication reinforced 14V alternator Right-hand driven
Project PTT Latvia •Mobile Monitoring System •based on Mercedes Benz MB312D •Sprinter, Standard 4 WD
Vehicle platform, Clark telescopic mast and vehicle design supplied by the customer, integration by R&S Warning system for driver to avoid movement of the vehicle when mast is not in parking position
Project PR China, Fujian •Mobile Monitoring System •based on Mercedes Benz MB412D •Sprinter, Standard 4 WD
Project PR China, Fujian Additional 28V alternator Compressor for Air-condition Two seating rows (6 persons)
Project RFD Vietnam •Mobile Monitoring System •based on Mercedes Benz MB412D •Sprinter, Special 4 WD
Project RFD Vietnam DF antennas 20 MHz to 3 GHz Lift for simple antenna installation 16“ heavy duty offroad tyres
Project RFD Vietnam Integrated Diesel Generator 3 Cyl. 1028 ccm
Power Supply and Air-condition Noise level (Operator room) < 60 dB(A) Combined air- and water cooling
Hardware Analyzer Spectrum Analyzer FSP 9 kHz – 40 GHz 1µs sweep time in time domain 21cm TFT colour display
Signal Analyzer FSQ 20 Hz – 40 GHz 120 MHz demodulation bandwidth
Hardware Direction Finder Digital Direction Finder DDF0xE High-end solution DF accuracy: 0,5° RMS DF speed: 10.000 channels/s Minimum signal duration: 10 µs
Hardware System Devices Antenna Control Units GB127
Mobile Microwave Monitoring Station 617,479.80