Maxfire Burn Drive Motor

Rex Engineering: Although you will never have a need to disassemble the brake mechanism, it is easier to see how it works if we break it down into the individual components.

This is all (4) of the brake components removed form the gearmotor

This is the two slot gear mounted to the motor armature. It is attached by an assembly that allows it to act as a clutch. It will allow the gear to slip to relive any stress that would be cause by a sudden stop

Ball Bearing

Gear box

Shaded poles

With the brake components removed, we can see the lower ball bearing and the two shaded poles Gap

The motor armature with the two slot gear has been added

The short locking arm and spring has been installed. Notice that the spring pulls the arm towards the center and into a slot

No Gap

Gap

The brake armature has been added. Observe the armature resting against the locking arm and the gap of the armature to the motor frame when the motor is de-energized

The brake armature has been added. Observe the armature resting against the motor frame and the lack of a gap of the armature to the motor frame when the motor is energized

15 of 30

The upper bearing assembly is now installed and the brake is completely assembled on the motor. The gearmotor is ready to install in the stove

SPG Co. Ltd.: Although you will never have a need to disassemble the brake mechanism, it is easier to see how it works if we break it down into the individual components.

This is all (3) of the brake components removed form the gearmotor

This is the two slot gear mounted to the motor armature. It is attached by an assembly that allows it to act as a clutch. It will allow the gear to slip to relive any stress that would be cause by a sudden stop

Shaded poles Ball Bearing

Gear box

With the brake components removed, we can see the lower ball bearing and the two shaded poles

The motor armature with the two slot gear has been added

The short locking arm and spring has been installed. Notice that the spring forces the arm towards the center and into a slot

No Gap Gap

Gap

The brake armature has been added. Observe the armature resting against the two slot gear and the gap of the armature to the motor frame when the motor is de-energized

The brake armature has been added. Observe the armature resting against the motor frame and the lack of a gap of the armature to the motor frame when the motor is energized 16 of 30

The upper bearing assembly is now installed and the brake is completely assembled on the motor. The gearmotor is ready to install in the stove