Cfl Inverter.docx

  • Uploaded by: raj
  • 0
  • 0
  • June 2020
  • PDF

This document was uploaded by user and they confirmed that they have the permission to share it. If you are author or own the copyright of this book, please report to us by using this DMCA report form. Report DMCA


Overview

Download & View Cfl Inverter.docx as PDF for free.

More details

  • Words: 323
  • Pages: 2
CFL emergency kit PUSH PULL application 12Volt 18Watt Push-pull applications make a more reliable waveform output than that of a fly back converter. Thus it can be used. The below circuit have a push-pull transformer, with two Switching transistors, whose base feedback is collected from the transformer itself (self oscillating).

This one has output power of up to 18Watt stated at 12V, though we can see the output is coupled by a series capacitor/diode here. The transformer has 5 lines at input section. Central connector goes to +VE supply, through a L1 inductor coil. It absorbs the spikes due to the switching of transformer. L1 should be 10mH to 100mH wit ferrite core. There two power stage pins, and two feedbacks goes to each of transistor’s collector, base. The initial base feeding is done by a 220 Ohm resistor to the base of any of the transistor, having a capacitor of 104(0.1uF) to the other transistor. This technology can be used for similar CFL lighting/ mobile charging etc applications which do rectify the input power to DC. The most advantage of this circuit is that this circuit glows CFL even at huge battery discharge. Experiments show, Light stays till battery voltage goes down to 5V. It’s not safe to run appliances up to that discharge level, as that would lead ‘sulphation’ to the battery plates. Here is used D880 or 1351 transistor for a output of 18Watt, but similarly we can use 2N3055 transistor in this setup with a big transformer to make output of up to 100W.

Front side of the PCB

Back side of the PCB

Application    

12V 18w DC to AC converter Can be connected to any 12v battery, 12v solar panel, 12v DC supply as input Output AC only for low watt cfl/LED bulb or mobile charger Use only for 12v DC application like 12v battery or DC 12v 1amp adaptor or 12v solar panel

Related Documents


More Documents from "allanedver"

Access Ays Issa
May 2020 12
Gimble
May 2020 11
Sample Booklet
April 2020 15
Yogesh1
May 2020 14