Process Of Assembly.docx

  • Uploaded by: Yours Always 12:30
  • 0
  • 0
  • November 2019
  • PDF

This document was uploaded by user and they confirmed that they have the permission to share it. If you are author or own the copyright of this book, please report to us by using this DMCA report form. Report DMCA


Overview

Download & View Process Of Assembly.docx as PDF for free.

More details

  • Words: 395
  • Pages: 1
Process of Assembly 1. make a plug on the bottom using a wood with a thickness of 1 inch. Measure the circumference of the pvc pipe for the plug to be exactly fit. 2. After measuring the circumference of the PVC pipe, transfer the measurement on the wood. Mark the measurement on the wood. 3. Using a saw, cut the marked measurement on the wood to be the plug. It should fit nice and precise when inserted in the PVC pipe. 4. On the circular wood that was cut, draw a smaller circle. Inside the circle, put holes using a driller. 5. Using a plastic bottle of a cola, mark a circle on the bottle then cut. The cicle should be measured one meter longer than the circle on the circular wood. Attach the plastic using a screw on the rectangular part. Make sure that the plastic can be flop even when it is attached. 6. Put the plug inside the PVC pipe with the plastic side as the one inside. 7. On the side of the pvc. pipe aligned with the plug, screw the plug to the pipe that the plug won’t fall out. 8. Using the same wood used for the plug, cut a circle again in accordance with the circumference of the pvc pipe but with a slightly looser. The circle wood should be able to be moved up and down inside the pipe. This will be the pump. 9. For the new circle wood, a wood stick will be attached on the center of the circle using a screw. This will serve as the handle. Drill the center of the circle attached the handle and on the bottom of the circle, use the screw to fix the attachment of the handle. 10. Draw a two circle besides the handle in a parallel manner. Using a drill, make the two circle a hole. 11. Using the plastic bottle again, make a cover for the two holes. Use a screw to attach the plastic. Make sure that the plastic can be flop even when it is attached. 12. On the middle of the pvc pipe, make a hole using a driller. 13. Using a screw, attach another smaller size of pvc pipe on the hole. 14. Connect a hose on the attached pvc for the water to flow.

Wood

Holes

Plastic bottle cut

Related Documents

Process
November 2019 54
Process
October 2019 58
Process
May 2020 16
Process Of Analysis As
December 2019 28
Process Of Change
May 2020 22

More Documents from "Satyam mishra"

Process Of Assembly.docx
November 2019 3
Internet Explorer
April 2020 34
Leonardo
April 2020 25