Man7.pdf

  • Uploaded by: Muhammad Faizal Axel
  • 0
  • 0
  • October 2019
  • PDF

This document was uploaded by user and they confirmed that they have the permission to share it. If you are author or own the copyright of this book, please report to us by using this DMCA report form. Report DMCA


Overview

Download & View Man7.pdf as PDF for free.

More details

  • Words: 232
  • Pages: 1
Checking and adjusting start of fuel delivery

Fig. 5 Remove screw plug (1) on governor housing. If fitted, take out blocking pin (2). If the pointer is exactly in the centre of the inspection hole, the pump plunger for cylinder no. 1 is at start of delivery. However, it is possible to determine exactly whether or not the pump is at start of delivery only by means of the following special tools:

a. Light signal transmitter

1

2

5 2310

Fig. 6 Push light signal transmitter into socket in governor housing. Ensure that the lug (3) fits in the groove (4). Tighten the knurled nut (5) by hand. Connect up power supply of light signal transmitter (red terminal = +). Turn engine by hand so that piston in cylinder no. 1 in the compression stroke comes close to the start of delivery. Lamp (A) comes on shortly before start of delivery is reached.

3

4

5 6 Fig. 7 Slowly turn the engine further until lamp (B) comes on too. The injection pump is now at start of delivery. The light signal transmitter KDEP 1600 (Fig.) is connected to the starter battery for the power supply. Note: If only lamp (B) comes on during this test, the engine has been turned past the start of delivery. In this case turn the engine back and repeat the procedure.

7 2308

24

6 2309

More Documents from "Muhammad Faizal Axel"

Man7.pdf
October 2019 6
Man8.pdf
October 2019 16
Man10.pdf
October 2019 12
Man9.pdf
October 2019 8