Job Safety Analysis Sheet JOB DESCRIPTION: ARC WELDING, CUTTING, GRINDING Facility: GC Work Area / Equipment:
JSA Ref. No. JSA / KOC / 05 Permit No. Date:
PERSONAL PROTECTIVE EQUIPMENT & TOOLS: Hard Hat, Safety Shoes, Apron, Welding Hood, Safety Goggles, Hand Gloves, Multi Gas Detector, SEQUENCE OF BASIC JOB STEPS
POTENTIAL HAZARDS Presence of flammable / toxic Vapor or Liquid
Yes / No
PRECAUTIONS
Ensure the worksite is free from flammable / toxic vapor or liquid by safe preparation (isolation, depressurizing, draining, venting, flushing, purging as required)
The entry of non – certified tools / equipment (Welding Transformer, Generator, Mobile Plant etc) to be authorized under Permit to Work System. Keep the fire extinguishers & fire hoses in ready condition. Keep trained fire watch as standby
Fire & Explosion
Planning
Non – compliance of KOC F & S Regulations and HSE MS Procedures
Refer Chapter -16 KOC F& S Regulations, HSEMS Procedures - Doc. No. SA.KOC.021 ‘Welding & Cutting’; Doc. No. SA.KOC.004 “Permit to Work”.
Unintended Shutdown of Facility / Equipment
Identify the safety override required for the work.
Unauthorized Work
Take a Hot Work Permit and other associated permits from Asset Owner.
Ensure the welding equipment (torch, cable, electrode holder, transformer, generator, cable connector, plugs, sockets etc) are free from defect and earthed as needed.
Radiation from UV / IR Rays (Flash Eye)
Wear protective goggles.
Exposure to Welding Fumes
Ensure proper ventilation and fume extraction equipment in case of welding inside an enclosure
Burns
Wear long sleeved coverall, leather apron; welder’s hood.
Falling of Sparks / hot bids
Enclose the welding area through tarpaulin.
Ensure the cables have proper insulation and connector as well as termination joints are safe for the purpose. Locate the emergency stop switch for immediate power isolation.
Defective Tools
Cutting / Welding
Electric Shock
Transformer / Generator near the Hot Work area
Windup & Housekeeping
Scattered Material
Keep Welding Generator at least 5 meters away from hot work area. Stop the generator when not in use. Ensure proper wind up & housekeeping at worksite. The accessories (torch, cable, electrode holder) not being used must be disconnected from transformer / generator and stored separately.
Additional Hazards (Other than indicated above)
JSA Done By
Name: KOC / ID. No. Controlling Team:PMC/AMEC/KOC Signature:
Designation: Company: SKEC Contract No.(If Applicable):26422 Date: