Dispensing and Sampling booth Booths are designed to give mixed air flow stream for product, operator and environmental protection and used to control the hazardous emissions of dust powder during powder dispensing / sampling process. 0.3 micron downward air stream deflects air-borne dust away from the operator breathing zone which is caused in handling operation. Dust particle available is being filtered at three levels of filtration prior to being circulated back to the booths air stream. Applications : Filling, refilling, weighing & sampling of Raw material & Components
Type
Front Open
Direction of flow
Vertical
Material of Construction
SS 304/ SS 316 or CRCA / GI Powder Coated
Cleanliness
Class 100 as per US FED STD 209E
Particle Retention
0.3 micron & above
Noise Level
65 dB on scale ‘A’ ± 5
Velocity
90 FPM ± 20%
Illumination
Flourescent tubes diffusers
Pressure Differential
0-25 mm inclined Manometers / Magnehelic Gauge
Power Supply
230 V Single Phase, 50Hz
Pre-Filters
10-15 micron rating, 3-Layers of HDPE mesh, 6mm Pressure Drop
Intermediaite Filters Supply HEPA Filters
3 micron & above, two layers of HDPE woven mesh and one layer of Non-woven polyester Bondex Media, 9mm Pressure Drop, Efficiency 97% 99.97% efficiency @ 0.3 micron rating
Exhaust HEPA Filters
99.97% efficiency @ 0.3 micron rating
Blower Assembly
Statically & Dynamically balanced DIDW type blower system
Special Features ? Designed in accordance with WHO / GMP ? 3-Stage Filteration like Prefilter, Fine Filter, HEPA filter ? Heavy duty Low noise motor blower assembly ? Suitable to accommodate on floor & table balances
25