Overview of ARM Evaluation Hardware - Developer Zone - National Instruments
Page 1 of 3
Improve your ni.com experience. Login or Create a user profile.
Document Type: Tutorial NI Supported: Yes Publish Date: Dec 1, 2008
Overview of ARM Evaluation Hardware Overview The LabVIEW Embedded Module for ARM Microcontrollers provides a selection of evaluation hardware boards that allow developers to prototype their ARM application before moving to custom ARM hardware. This document will detail board features, processor specifications and links to find more information from the manufacturer. Table of Contents 1. 2. 3.
Luminary Micro LM3S8962 Evaluation Board Keil MCB2300 Evaluation Board More Information
Luminary Micro LM3S8962 Evaluation Board
Microcontroller Manufacturer: Luminary Micro Evaluation Board Manufacturer: Luminary Micro Processor Type: ARM Cortex-M3 LM3S8962 Evaluation Board features: 1 CAN interface SD Card interface OLED graphics display with 128 x 96 pixel resolution User LED, navigation switches, and select pushbuttons Ethernet Analog Input Analog Output Processor Specifications:
http://zone.ni.com/devzone/cda/tut/p/id/8078
12/14/2008
Overview of ARM Evaluation Hardware - Developer Zone - National Instruments
Page 2 of 3
256KB Flash ROM 64KB SRAM 50MHz 6 Motion Control PWM Ethernet MAC + PHY 1 CAN 1 UART 8 10-bit ADC 1 Analog Comparator 38 GPIO Pins Related LM3S8962 Links Evaluation Board Information Processor Overview Full Processor Specifications Keil MCB2300 Evaluation Board
Microcontroller Manufacturer: NXP Evaluation Board Manufacturer: Keil Processor Type: ARM7 NXP LPC2378 Evaluation Board features: 2 serial interfaces speaker analog input (via potentiometer) 2 CAN interfaces LCD USB Ethernet 8 LEDs
http://zone.ni.com/devzone/cda/tut/p/id/8078
12/14/2008
Overview of ARM Evaluation Hardware - Developer Zone - National Instruments
Page 3 of 3
Processor Specifications: 512KB on-chip Flash ROM 58KB RAM CPU clock up to 72 MHz Ethernet 10/100 MAC with DMA External Memory Controller for static devices such as Flash and SRAM USB 2.0 Full Speed Device Controller CAN 2.0B with two channels 4 UARTs 3 I2C serial interfaces 3 SPI/SSP serial interfaces SD/MMC memory-card interface 10-bit ADC with 8 channels 10-bit DAC PWM unit for three-phase motor control General purpose I/O pins Related MCB2300 Links Evaluation Board Information Processor Overview Full Processor Specifications More Information To learn more about the LabVIEW Embedded module for ARM Microcontrollers, visit www.ni.com/arm. Reader Comments | Submit a comment »
Legal This tutorial (this "tutorial") was developed by National Instruments ("NI"). Although technical support of this tutorial may be made available by National Instruments, the content in this tutorial may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this content with each new revision of related products and drivers. THIS TUTORIAL IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).
My Profile | RSS | Privacy | Legal | Contact NI © 2008 National Instruments Corporation. All rights reserved.
http://zone.ni.com/devzone/cda/tut/p/id/8078
|
E-Mail this Page
12/14/2008