Triumph Rocket 3 - Flaminred Project

Project: Flamin’Red Rocket The fol lowing are images t aken from the 3 main pictures I sent to y ou showing the de tail ing neede d for the paint job on m y Rocket 3 tins y ou have. FL YSCREEN

OI L T ANK

** NB : PLE ASE NOTE THE W HITE LI NES ARO UND AL L OF THE BL ACK AND AL SO TH E SHADOWI NG ARO UND THE FL AMES

1

Project: Flamin’Red Rocket Rear Fen der

Front Fen der

2

Project: Flamin’Red Rocket PE TROL T ANK

NB : PLEA SE NOTE THA T THE P ATTERN IS SYM ETR ICAL FROM THE C ENTRE OF THE FUEL FIL LER PORT A ND ALSO, NOTE TH E B LACK “BACKGRO UND” RUN NI NG AROU ND THE LIP OF THE T ANK

3

Project: Flamin’Red Rocket

Mo dification

to Body work

Rear mu d guard 1. Rear mud guard cut off above the rear tail light; 2.

The new shortened tail light should follow a slight round profile as below;

4

Project: Flamin’Red Rocket Front m ud guard 3.

4.

Front mud guard reduced by 3 inches on the rear and 3 inches on the front – send me some pictures once cut down so I can check its the right size; Both front and rear parts of the front mud guard to follow the same profile as the original (similar to the one below but not identical);

5

Project: Flamin’Red Rocket Side panels 5.

Badges removed from both the side panels and filled as picture below;

Oi l T ank 6.

Oil tank indentation filled if possible so a smooth image such as below can be put on;

6

Project: Flamin’Red Rocket Chromes to b and painted 7.

8.

e suppl ied via the post

sho rtly

Fork wind deflectors (x2) such as the black ones shown below – Painted BLACK OR AS MAIN SCHEME IF POSSIBLE

Radiator surround (x1) as shown below – PAINTED AS MAIN SCHEME IF POSSIBLE

7

Project: Flamin’Red Rocket 9.

10.

Rear peg triangle (x2) such as the black one shown below – PAINTED AS MAIN SCHEME IF POSSIBLE

Sissy bar edges (x2) shown as below. Paint scheme on the rear mud guard should continue on to the chromes (also as shown below):

8

Project: Flamin’Red Rocket 11.

Bear claw (x1) such as the one shown below. Paint scheme on the petrol tank should continue on to the bear claw (also as shown below):

9