Cut Diagrams for Stampin’ Up! O Christmas Tree pop-up Bigz XL Die #116822 12x12 CARDSTOCK OR PAPER: (one sheet required per tree)
8.5x11 CARDSTOCK OR PAPER: (one and 1/3 sheets required per tree)
12”
11”
(30.5cm)
5”
(12.7cm)
(28cm)
5”
Entire Die (textured/patterned side up)
Med. Tree Med. Tree Sm. Tree Part Part Part (texture/ (texture/ (8.9cm) pattern up) pattern dn) Not Med. Tree Sm. Sm. Used 3.5” Part Tree Tree (8.9cm) (texture/ Part Part pattern dn)
3.5”
4”
(10.2cm)
2”
2”
(5cm) (5cm)
(12.7cm)
2”
5”
3.5”
(8.9cm)
4”
2.5”
(10.2cm)
(6.4cm)
2” 2”
CUT SEQUENCE:
(5cm)
1.
(5cm)
3. 4. 5. 6.
®
To find a Stampin’ Up! demonstrator in your area: www.stampinup.com
the small tree part will be cut off (and that’s OK!)
Med. Tree Med. Tree Med. Tree Part Part Part (texture/ (texture/ (texture/ (8.9cm) pattern up) pattern dn) pattern dn)
(12.7cm)
Cover all pieces on the die with the long strip, texture or pattern facing up, and cut. (Note: if using 8.5x11 the smallest tree part will only be partially covered by the strip, so discard the incomplete small piece after cutting) Cover the Medium Tree Part with one pre-cut piece, textured/patterned side up, and cut. Cover the Medium Tree Part with one pre-cut piece, textured/patterned side down, and cut. Cover the Medium Tree Part with one pre-cut piece, textured/patterned side down, and cut. Cover the Small Tree Part with three pre-cut pieces, texture/pattern up or down, and cut. If using 8.5x11 cardstock, repeat Step 5 with the final pre-cut piece.
Entire Die (textured/patterned side up)
3.5”
(5cm)
(5cm)
2.
®
2”
Sm. Tree Part Sm. Tree Part Sm. Tree Part
3.5”
(8.9cm)
4”
(10.2cm)
8.5”
(21.6cm)
Not Used
Sm. Tree (6.4cm) Part
2.5”
GENERAL NOTES: 1.
2.
If using non-textured cardstock, the notations about “texture/pattern up/down” do not apply. Simply die cut the pieces. “Pieces with creases” should always be cut one sheet at a time. Pieces without creases (in this case, the Small Tree Part) can be cut up to three sheets at a time. © 2009 Karen Burniston All rights reserved.