LIST OF ATTEMPTED QUESTIONS AND ANSWERS True/False Question
Maintenance department evaluation can be done by only one method. Correct Answer False Your Answer
False
Multiple Choice Multiple Answer Question What are the content of initial cost? Correct Answer Taxes , Basic Cost , Installation Charges Your Answer
Basic Cost , Installation Charges , Taxes
Multiple Choice Single Answer Question Who, due to fear of losing the maintenance contract, may not reveal enough technical information? Correct Answer Vendor Your Answer
Vendor
True/False Question
Defect analysis gives us information about commonly faced problems. Correct Answer True Your Answer
True
Select The Blank Question In India, most of the industrialist base their decisions to purchase equipment on the ________. Correct Answer Price of the equipment Your Answer
Price of the equipment
Match The Following Question
Correct Answer
Your Answer
Time taken
As low as possible
As low as possible
Automation
Decrease break down time
0.99
Utilization of machine
As high as possible
As high as possible
Equipment selection
Purchase dept
Purchase dept
Multiple Choice Single Answer Question Which document is called horoscope of that particular equipment which can tell a lot about it to experienced engineer? Correct Answer History Card Your Answer
History Card
Multiple Choice Multiple Answer Question Which of the following are the constituents of fire? Correct Answer Fuel , Heat , Oxygen Your Answer
Fuel , Heat , Oxygen
Multiple Choice Multiple Answer Question Maintenance Control system is used to check following? Correct Answer Correct starting time of Maintenance activities , Maintenance planning , To get correct feedback Your Answer Correct starting time of Maintenance activities , Maintenance planning , To get correct feedback Multiple Choice Multiple Answer Question The maintenance department is responsible for :Correct Answer Protection of building and plant , Increasing utilization of plant , Controlling maintenance cost Your Answer Protection of building and plant , Increasing utilization of plant , Controlling maintenance cost Multiple Choice Single Answer Question Normally Ratio of Unplanned work to planned work is given in :Correct Answer Maintenance Report & Analysis Your Answer
Maintenance Report & Analysis
Multiple Choice Single Answer Question Which type of inspection is to be carried when the machine is operating? Correct Answer One-time inspection Your Answer
Sample inspection
True/False Question
Reliability is the probability that product will perform its intended functions under desired operating conditions over a specified period of time. Correct Answer True Your Answer
True
Multiple Choice Single Answer Question The flat part in the bath tub curve is called :Correct Answer Normal Life Time Your Answer
Normal Life Time
True/False Question
Hazardeous chemicals inventory should be kept at minimum level Correct Answer True Your Answer
True
Multiple Choice Single Answer Question Which of the following is process variable which can affect the equipment? Correct Answer Flow rate of process fluid Your Answer
Flow rate of process fluid
Multiple Choice Multiple Answer Question Following are the part of service installations in the buildings? Correct Answer Asset register , Technical manuals , Suppliers manuals Your Answer
Asset register , Technical manuals , Suppliers manuals
Multiple Choice Single Answer Question Which analysis gives information about faced problems, and solution to avoid it? Correct Answer Defect Analysis Your Answer
Defect Analysis
Select The Blank Question Correct quantity of lubricant assures that lubricant will be used in optimum quantity and will result in ________.
Correct Answer Economy Your Answer
Thermal stability
Multiple Choice Single Answer Question The supplier should be competent enough to estimate & provide means of reducing :Correct Answer Down time as minimum as possible Your Answer
Wear out as minimum as possible
Select The Blank Question In Japan & Western countries equipment discarded after about ________ years. Correct Answer 7 Your Answer
5
Select The Blank Question The manufacturing time for spare parts can vary from________. Correct Answer Zero to one year Your Answer
1 day to 8 days
Multiple Choice Multiple Answer Question What are the basis on which training programmes are designed? Correct Answer Needs of Organisation , Type of Organisation , Category of Pupils Your Answer Needs of Organisation , Type of Organisation , Top Management
Multiple Choice Multiple Answer Question Some of the elements of inventory carrying cost are :Correct Answer Storage expenses , Insurance charges , Cost of deterioration Your Answer
Storage expenses , Insurance charges , Cost of deterioration
Select The Blank Question ________ should be allowed in case of real emergency. Correct Answer Contingency purchasing Your Answer
JIT purchasing
Multiple Choice Multiple Answer Question Which are probable period of annual shut Downs in the Year? Correct Answer Demand for a product is Low , Festival Seasons , Supply of Raw material is nil. Your Answer Demand for a product is Low , Festival Seasons , Supply of Raw material is nil. Select The Blank Question Reliability can be expressed as probability between________. Correct Answer 0 to 1 Your Answer
0 to 100
True/False Question
Animal fats can be used as lubricants.
Correct Answer True Your Answer
True
Multiple Choice Multiple Answer Question Master list of all the supplier should consist of information such as :Correct Answer Name, address, telephone, fax nos , Financial status , His rating for the year. Your Answer Name, address, telephone, fax nos , Financial status , His rating for the year. True/False Question
Indian Standards Institution is Indian body of standardization.
Correct Answer True Your Answer
True
True/False Question
Audio cassettes are the part of tools of training.
Correct Answer True Your Answer
True
Multiple Choice Single Answer Question What is necessary to avoid major breakdowns? Correct Answer Maintenance at right time
Your Answer
Maintenance at right time
Multiple Choice Multiple Answer Question What type of details are given in Work order? Correct Answer Specifications , Drawings , Manuals issued Your Answer
Specifications , Drawings , Manuals issued
True/False Question
Handling instruction is transportation instructions.
Correct Answer True Your Answer
True
Multiple Choice Single Answer Question What type of task it is to repair & maintenance fire fighting system? Correct Answer Repetitive task Your Answer
Single contract task
True/False Question
Proper communication with related departments can result in increased cost of spare. Correct Answer False Your Answer
False
Multiple Choice Multiple Answer Question What type of support equipments are required in Maintenance? Correct Answer Tools , Spare Parts , Test Equipments Your Answer
Tools , Spare Parts , Test Equipments
Match The Following Question
Correct Answer
Your Answer
Grease cups lubrication
Every week
Every week
Gear box sumps lubrication
Every six months
Every six months
Electrical motor bearing lubrication
Every year
Every year
Oil nipple lubricated parts Every day lubrication
Every day
Multiple Choice Multiple Answer Question The performance of maintenance is indicated by :Correct Answer Low cost , Low down time , More uptime Your Answer
Low cost , Low down time , More uptime
Multiple Choice Single Answer Question Lubrication helps in :Correct Answer Increase life of wear and tear parts Your Answer
Increase life of wear and tear parts
Select The Blank Question Availability of ________ equipment is considered while deciding maintenance system. Correct Answer Stand by Your Answer
Stand by
Select The Blank Question ________ ratio should be as high as possible. Correct Answer Planned maintenance work Your Answer
Maintenance cost percentage to total sale
Select The Blank Question The correct procedure is applied there is less chance of any ________. Correct Answer Mistakes Your Answer
Mistakes
Multiple Choice Single Answer Question Who is responsible for the design of proper maintenance system? Correct Answer Maintenance manger Your Answer
Maintenance manger
Select The Blank
Question
Spare part lists will be comprehensive for complex equipment with section wise details along with ________. Correct Answer Order code numbers Your Answer
Part number
True/False Question
Preventive maintenance program reduces overall maintenance cost which also include spare cost. Correct Answer True Your Answer
True
Select The Blank Question The ________ is done to check performance efficiency of a plant. Correct Answer Technological Review Your Answer
Control Quality
Select The Blank Question
When a new executive joins the organisation he is usually given________.
Correct Answer
Induction training
Your Answer
Induction training
Select The Blank Question
A unit called ________ measures illumination.
Correct Answer
Lux
Your Answer
Lux
True/False Question
Value analysis is one way to attempt for quality simplification.
Correct Answer
True
Your Answer
True
True/False Question
A timely corrective action avoids major fault.
Correct Answer
True
Your Answer
True
Multiple Choice Multiple Answer Question The codification can be done by following methods :Correct Answer
Mnemonics method , Decimal method , Field method numerical codes
Your Answer
Mnemonics method , Special characters method , Decimal method , Field method numerical codes
Multiple Choice Multiple Answer Question What are the constituents of operating cost? Correct Answer
Cost of Equipment , Cost of Modifications , Cost of Tooling
Your Answer
Cost of Equipment , Cost of Modifications , Cost of Tooling , Cost of Transportation
Multiple Choice Single Answer Question If equipment creates noise above permissible level then :-
Correct Answer
It may produce vibration which may affect other equipment.
Your Answer
It is recommended not to purchase such equipment.
Select The Blank Question Correct Answer
According to Lubrication Schedule provision of ________ is given for maintenance. Plant Shut Down
Your Answer
Lubrication
Match The Following Question
Correct Answer
Your Answer
Attention value category
Frequency breakdown equipment
Frequency breakdown equipment
Vital category
Critical equipment
Critical equipment
Essential category
Semi critical equipment
Semi critical equipment
Normal category
Non critical equipment
Non critical equipment
Select The Blank Question
The spark can be generated due to ________ faults.
Correct Answer
Phase to phase
Your Answer
Phase to phase
Multiple Choice Multiple Answer Question Satisfactory performance of maintenance contractor is :Correct Answer
Quality of work , Skills of manpower , Equipment performance
Your Answer
Quality of work , Skills of manpower , Equipment performance , High cost
Select The Blank Question
Quality should not be ________ at the cost of lower price.
Correct Answer
Sacrificed
Your Answer
Sacrificed
Multiple Choice Single Answer Question How a molecule of fuel fragmented? Correct Answer
H+ and OH-
Your Answer
H2O+CO2
True/False Question Correct Answer
Shelves, Closets such fittings are consider as costing centers for buildings in the assets register. True
Your Answer
True
Multiple Choice Multiple Answer Question Evaluation of maintenance function can be done by taking following steps :Correct Answer
Your Answer
Set the achievable targets for maintenance dept for the expected performance , Check results against set targets , Find out reasons for variance Set the achievable targets for maintenance dept for the expected performance , Check results against set targets , Find out reasons for variance , Not to take any remedial action
Multiple Choice Multiple Answer Question The energy saving can be achieved by following ways :Correct Answer Your Answer
By avoiding excess use , By avoiding wastage , By increasing efficiency of the equipment By increasing inductive load , By avoiding excess use , By avoiding wastage , By increasing efficiency of the equipment
Multiple Choice Single Answer Question The responsibility of maintenance Department is to ensure cost at :Correct Answer
Minimum
Your Answer
Minimum
True/False Question Correct Answer
Demulsibility is separating water from oil when the machine are kept stand still. True
Your Answer
True
Select The Blank Question Correct Answer
There are two types of cost involved with any asset, one is the ________ and second is initial cost. Running Cost
Your Answer
Running Cost
Multiple Choice Single Answer Question It is objective of maintenance to make maximum availability of production plant at :Correct Answer Minimum cost
Your Answer
All time
Multiple Choice Single Answer Question Which type of maintenance is called to the maintenance work initiated as a result knowledge of the condition of an item from routine checking? Correct Answer Condition based maintenance Your Answer
Condition based maintenance
True/False Question
On line inspection is carried out on machine itself but when it is shut down.
Correct Answer
False
Your Answer
False
Multiple Choice Single Answer Question In any organization generally called thankless department is :Correct Answer
Maintenance
Your Answer
Maintenance
Select The Blank Question Correct Answer
Spare part lists will be comprehensive for complex equipment with section wise details along with ________. Order code numbers
Your Answer
Order code numbers
Select The Blank Question Correct Answer
The progress of work inside the plant can be viewed at glance by putting up a ________ in the control room. Schedule Board
Your Answer
Schedule Board
Select The Blank Question
Reliability can be expressed as probability between________.
Correct Answer
0 to 1
Your Answer
0 to 1
Multiple Choice Single Answer Question Which analysis gives information about faced problems, and solution to avoid it? Correct Answer Defect Analysis Your Answer
Defect Analysis
Multiple Choice Multiple Answer Question In the objective evaluation method, the performance indicators are :Correct Answer
Overtime ratio , Availability of plant ratio , Spare part ratio
Your Answer
Working capital ratio , Spare part ratio , Overtime ratio , Availability of plant ratio
Multiple Choice Multiple Answer Question The price of the spare part depends on :Correct Answer
Demand and supply position , Urgency of buyer , Level of negotiations
Your Answer
Demand and supply position , Urgency of buyer , Level of negotiations , Type of customer
True/False Question Correct Answer
Computers can be used to predict failures and breakdowns by simulation method well in advance. True
Your Answer
True
True/False Question
The schedule of lubrication of equipment is not a part of maintenance plan.
Correct Answer
False
Your Answer
False
Multiple Choice Single Answer Question Preventive maintenance :Correct Answer
Anticipates failures and necessary action
Your Answer
Anticipates failures and necessary action
Multiple Choice Multiple Answer Question Characteristics of spare parts are :Correct Answer Your Answer
The requirement of spares increases with the machine getting older. , The stock out cost is always greater than the cost of spare parts. , There is always possibility of duplication in the storage. The requirement of spares increases with the machine getting older. , The stock out cost is always greater than the cost of spare parts. , There is always possibility of duplication in the storage. , Identified by the type & group.
Multiple Choice Multiple Answer Question What are the consisitutent of lubricating oil? Correct Answer
Mineral oil , Chemical compounds , Vegetables oils
Your Answer
True/False Question
Mineral oil , Chemical compounds , Vegetables oils , Saw dust
Correct Answer
Maintainability is defined as ease with which product can be serviced or repaired. True
Your Answer
True
True/False Question Correct Answer
Reconditioning is bringing the old used part to its original condition by using engineering process. True
Your Answer
True
Multiple Choice Single Answer Question It is said that a failure never occurs without :Correct Answer
Warnings
Your Answer
Warnings
Multiple Choice Multiple Answer Question Which utilities require to be planned as a function of maintenance manager? Correct Answer
Electricity , Waste disposal , Steam & gas
Your Answer
Electricity , Waste disposal , Steam & gas
Select The Blank Question
The contract service is ________.
Correct Answer
Too expensive
Your Answer
Expensive
Multiple Choice Single Answer Question One of the desired condition, which is required in a proper coding of the overheads is :Correct Answer The people who operate it should easily remember it. Your Answer
It should not allow manual intervention
Multiple Choice Single Answer Question As the frequency of maintenance is stepped up preventive maintenance cost :Correct Answer Shoots up Your Answer
Shoots up
Multiple Choice Multiple Answer Question In the off line inspection, which parameters can be monitored? Correct Answer
Crack detection , Alignment of connecting equipments , Lubricating oils
Your Answer
Digital system , Crack detection , Alignment of connecting equipments , Lubricating oils
Multiple Choice Multiple Answer Question What information is given in a manual of building? Correct Answer Your Answer
Maintenance of building , Schedule of maintenance , Description of maintenance Maintenance of building , Schedule of maintenance , Description of maintenance
True/False Question
Most of the ordering costs are fixed in nature.
Correct Answer
True
Your Answer
True
Multiple Choice Single Answer Question Which of the following is one of the causes of fire? Correct Answer
Smoking
Your Answer
Smoking
Match The Following Question
Correct Answer
Your Answer
Maintenance Record
Recording of Time and Money
Recording of Time and Money
Asset Register
List of All Assets of Plant
List of All Assets of Plant
Maintenance Schedule
Instruction on Doing Maintenance
Scheduling on rolling basis
Principles of Scheduling
Scheduling on rolling basis
PERT
Select The Blank Question Correct Answer
________ should be planned so that workers can approach the equipment easily. Gangways
Your Answer
Gangways