Ip Super Netting Or Cidr

IP Supernetting or CIDR CIDR stands for "Classless Inter-Domain Routing". It is a new addressing scheme for the Internet, intended to replace the old classful (Class A, B, C) address scheme. CIDR allows a more efficient allocation of IP addresses and uses routing aggregation for minimizing the routing table entries, and is also called supernetting. A recapitulation of classful IP addressing shows us the following: Address Class Class A Class B   

Number of Network Bits 8 bits 16 bits

Number of Hosts Bits 24 bits 16 bits

Decimal Address Range 1-126 128-191

126 class A networks with up to 16,777,214 hosts each 65,000 class B networks with up to 65,534 hosts each Over 2 million class C networks with 254 hosts each

If a provider needed 10,000 IP addresses for a project, then it would receive a class B network, and 55,534 IP addresses would not be used. If however, the provider had been assigned 40 class C networks for that 10,000 IP addresses, it could not match its needs (not all the IP addresses would be in the same network) and the routing tables of routers on the Internet would grow with 40 new routes. CIDR is an addressing scheme that supports masks not only of 8, 16, or 24 bits as in classful routing but of arbitrary length. The CIDR notation is: xxx.xxx.xxx.xxx/n where xxx.xxx.xxx.xxx is the IP address of the network and "n" is the number of '1' bits in the mask. For example, the class C network 192.168.1.0 with the mask 255.255.255.0 is written in CIDR as 192.168.1.0/24. The CIDR masks for classes A, B, and C respectively are /8, /16, and /24. For the earlier example with the provider requesting 10,000 IP addresses, with CIDR the provider would be assigned a network having a mask of /18, meaning the subnet mask would be 255.255.192.0 with 16,382 usable IP addresses and only one prefix in all the routing tables in the world. Nowadays, providers are assigned large blocks of addresses that their customers can buy instead of every customer having different IP classes. For example, the provider that was assigned a /18 network can give 64 of its customers a class C IP class (a /24). This is called aggregation, and it significantly reduces the size of the routing tables on the Internet.

Page 1 of 2

Let's have a look at the CIDR prefixes down to /16 (class B): CIDR Prefix /32

Subnet Mask 255.255.255.255

/30 /29 /28 /27 /26 /25 /24 /23 /22 /21 /20 /19 /18 /17 /16

255.255.255.252 255.255.255.248 255.255.255.240 255.255.255.224 255.255.255.192 255.255.255.128 255.255.255.0 255.255.254.0 255.255.252.0 255.255.248.0 255.255.240.0 255.255.224.0 255.255.192.0 255.255.128.0 255.255.0.0

Number of IP Addresses /32 is used in CIDR to specify a single host or IP address. If the prefix is missing, /32 is assumed 4 8 16 32 64 128 256 512 1024 2048 4096 8192 16384 32768 65536

How the Internet Works Large providers are assigned large IP blocks for them and for their customers. When accessing an IP address outside the provider's network, the data must travel through certain routers to get to the destination IP. The Internet Protocol is responsible for routing the packet to the destination. Providers have some large, carrier-class routers located at the edge of their network where they interconnect to other providers. Every provider that has at least two interconnections with two different other providers must have an Autonomous System (AS) number to be identified in the exchange of routing information. All the Internet is based on BGP (Border Gateway Protocol), which is a dynamic routing protocol used to exchange information between providers about the networks they have. A provider having the Autonomous System number 1 (AS 1) has two interconnections: one with AS 2 and another with AS 3. Depending on the agreement between the providers, AS 1 can route to either of them only their own networks (Local Exchange or Local Peerings), or it can announce all the routes received from other peers (Full Exchange or Full BGP). AS 3 can receive the routes to AS 1 networks directly from AS 1, and can also receive them from AS 2 and AS 4. The router finds the best path to AS 1 networks and sends packets to those networks on that path, and if that link fails, on the next best path. (e.g. AS 3 sends the packets to AS 1 directly on their interconnection. If that link fails, it will send them to AS 2, which will forward the packets to AS 1.)

Page 2 of 2