FRONT BUMPER REMOVAL/INSTALLATION
id091000405100
1. Disconnect the negative battery cable. (Vehicles with front fog lights) 2. Remove screw A and screws B, and set the mudguard out of the way in the direction of the arrow shown in the figure. SCREW A
MUDGUARD
SCREW B am2zzw00001602
3. Remove screws C.
FRONT BUMPER
SCREW C
FRONT
am2zzw00003465
4. Remove the fastener D.
FASTENER D
RADIATOR GRILLE
am2zzw00001604
5. Remove the bolts from position (1) indicated in the figure, pull the front bumper in the direction of arrow (2) shown in the figure to disengage the both ends from the front bumper slider, then remove the front bumper in the direction of arrow (3).
FRONT BUMPER SLIDER TAB
(1) BOLT
(1) BOLT
(2) FRONT BUMPER
(2)
(2)
FRONT BUMPER TAB (3) FRONT BUMPER SLIDER
BOLT:6.9—9.8 N·m {71—99 kgf·cm,62—86 in·lbf}
am2zzw00001787
Caution • The front bumper and front bumper slider are engaged firmly. If they are disengaged forcibly the bumper could fall and be damaged. Perform the servicing carefully when disengaging the front bumper from the front bumper slider. • When disengaging the front bumper from the front bumper slider, the front bumper could fall and be damaged. Support the front bumper so that it does not fall. 6. Disconnect the front fog light connector. (Vehicles with front fog lights) 7. Install in the reverse order of removal. 8. Adjust the front fog light aiming for vehicles with front fog lights. (See FRONT FOG LIGHT AIMING) Front Bumper Installation Note 1. Spread the front bumper ends apart. 2. Assemble the front bumper to the body. 3. Press the front bumper connecting area in the direction of the arrow shown in the figure to engage with the front bumper slider.
FRONT BUMPER SLIDER
FRONT BUMPER am2zzw00001606