PANIMALAR ENGINEERING COLLEGE, CHENNAI Department of Mechanical Engineering ENGINEERING GRAPHICS FACULTY: P.MOHANAVELU
DEPT : CIVIL
PLANE SURFACE PERPENDICULAR TO HP & RESTING ON HP ON CORNER 1. Draw the projection of hexagonal surface of side 30 mm inclined at 40 degree to VP and surface inclined at 40 degree to HP .Hexagonal surface is resting on HP through one of its corner. 2. A rectangular lamina of 100 x 40 resting on HP on one of its corner with its surface inclined at 20 degree to HP. Draw its projection when its diagonal is inclined at 80 degree to VP. 3. A pentagonal plate of side 30 mm resting on HP through one of its corner with two side containing the corner is equally inclined to VP. Draw its front view and top view when the surface is inclined at 30 degree to HP. 4. A square plate PQRS of side 35 mm rests on ground on one of its corner with sides containing the corner equally inclined to VP. Draw its projection when the surface is inclined at 30 degree to HP. 5. Draw the projection of semicircular of diameter 60 mm rests on ground on one of its corner with surface inclined at 45 degree to HP. The side containing the corner is inclined at 45 degree to VP.
PLANE SURFACE PERPENDICULAR TO VP & RESTING ON VP ON SIDE 6. Draw the projection of hexagonal plate of side 40 mm lying on VP on one of its side with surface inclined at 40 degree to VP and resting side is equally inclined to HP . 7. A pentagonal lamina of side 35 mm rests on VP on one of its side inclined at 40 degree to HP. The surface is inclined at 40 degree to VP. Draw its projection.. 8. A rectangular plate 70 x 40 mm has its one of shorter edge on VP inclined at 40 degree to HP. Draw its top view if its front view is a square of side 40 mm. 9. A triangular plate PQR of side PQ = 50 mm, QR=70 mm and RS=40mm. The side PQ rests on VP and is inclined at 30 degree to HP. The surface is inclined at 40 degree to VP. Draw its projection. PLANE SURFACE PERPENDICULAR TO VP & RESTING ON VP ON CORNER 10.Draw the projection of hexagonal plate of side 40 mm lying on VP on one of its corner with surface inclined at 50 degree to VP and diagonal containing the corner is inclined 40 degree to HP . 11.A pentagonal lamina of side 40 mm rests on VP on a corner while the two side containing the corner is equally inclined to HP. The surface is inclined at 40 degree to VP. Draw its projection.(USE proper scale) 12.A rectangular plate 10 x 4 meter has its one of corner on VP with shorter edge inclined at 50 degree to HP .Draw its projection if the surface is inclined at 40 degree to VP.