C-Itoh, Model 8510 Printer, Centronics interface (parallel) Switches and vars inside the case: SW1 +---------------+ | | | | | | | | | | | | | | | | | | -open +---------------+ VR2 VR1 8 1 /-\ /-\ | | | | \-/ \-/ SW2 IMPRES. ALIGN. +---------------+ | | | | | | | | | | | | | | | | | | -open +---------------+ 8 1 SW1:
Pin 1 2 3 4 5 6 7 8
SW2:
frontpanel | | V
\ National character set. 000=Japan, 010=USA, } 110=UK, 001=Germany, 101=Swedish / 0=66 lines/page, 1=72 lines/page 0=DC1, DC3 effective; 1=ignored 1=line feed for too-long line 1=CR emulated when LF, VT, FF recieved 0=CR does only cr; 1=CR forces LF too
Pin 1 1=zero has a line through it 2 0=multiple-line buffer 3 unused 4 unused 5 0=10 cpi, 1=proportional -- font at power-up 6 0=8-bit data, 1=7-bit data 7 1=selected at power-on 8 0=bidirectional printing
VR1/ALIGN. : adjust to make bidirectional printing line up horizontally. Print a pattern with the | character, and adjust so they fall exactly in line. VR2/IMPRES.: adjust if printing is too faint. The book does not describe how this is done, as a worn ribbon will also give faint printing. Selection of Optional Functions * As shipped Switch 2-1
Note:
Status X O
Result/Function Slashed Zero * Un-Slashed Zero
2-2
X O
Device Address Effective * Inneffective
2-3 2-4
O O
* Device Address 1 /
2-3 2-4
X O
Device Address 2 /
2-3 2-4
O X
Device Address 3 /
2-3 2-4
X X
Device Address 4 /
2-5 2-5
O X
* 10 CPI character Proportional character
2-6 2-6
X O
7 bit data * 8 bit data
2-7 2-7
X O
Power-On Selected * Power-On Deselected
2-8 2-8
X O
Unidirectional Print * Bidirectional Print
Up to four printers may be connected through the same cable to the host. The device address allows selection of each printer. Switches 2-2/3/4 relate to this capability. The printers are selected by escape sequence sent by the host as follows: ESC ESC ESC ESC ESC
a b c d '
Select printer 1 Select printer 2 Select printer 3 Select printer 4 Deselect all printers