Origami.docx

ORIGAMI FISH 1

Step 1: Start with a square piece of paper

2

Step 2: Fold the the upper left corner to the lower right corner, then unfold.

3

Step 3: Fold the upper right corner to the lower left corner, then unfold.

4

Step 4: Fold the top half back, then unfold.

5

Step 5: Poke the center with your finger so that the center pops in.

6

Step 6: Bring the left and right sides together so that the paper collapses into a triangle.

7

Step 7: Rotate the triangle left 90° (counter-clockwise).

8

Step 8: Fold the bottom corner up a little above the center as shown

9

Step 9: Fold the top flap over the bottom one as shown.

10

Step 10: Turn the fish over and you're done. Draw the eye and some stripes to make it look nice!

ORIGAMI FROG 1

Step 1: Start with a regular piece of rectangle paper. An 8.5x11 paper is fine.

2

Step 2: Fold the top left corner to the right side, making the top right corner as pointy as possible. Then unfold.

3

Step 3: Repeat Step 2 with the other corner.Unfold

4

Step 4: Fold back the top from where the "X" creases meet. Unfold

5

Step 5: Bring the creases together to form a triangle at the top.

6

Step 6: Fold the left corner of the triangle to the top of the triangle.

7

Step 7: Repeat with the right corner.

8

Step 8: Fold the sides to the center.

9

Step 9: Fold the bottom corners to the corners of the "diamond"

10

Step 10: Fold the bottom rectangle in half.

11

Step 11: Turn the frog over and add some eyeballs. Press down on the edge of the back to make it jump!

ORIGAMI CRANE 1

Step 1: Start with a regular piece of square paper.

2

Step 2: Fold the paper in half by taking the top corner and folding it to the bottom corner. The crease should run from the left corner tip to the right like in this picture. Use your nails to make a sharp crease.

3

Step 3: Fold the triangle in half by taking the left corner and folding it to the right.

4

Step 4: Take the top flap and open it, creasing the left and right sides so you can fold the the top/right corner to the bottom corner

5

Step 5: Now we'll turn the paper over and do the same thing to the other side.

6

Step 6: To do that, lift the left flap up so it stands vertically like the picture.

7

Step 7: Grab the left and right side of the flap and open it up. Crease the sides so you can fold the top corner down to the bottom.

8

Step 8: Take both sides of the top layer and fold them in to meet at the middle, then unfold. This step is preparation for the next step.

9

Step 9: Open the flap upwards.

10

Step 10: Fold the left and right sides inward.

11

Step 11: Flip it over and repeat steps 8 to 10. It should look like this when you're done.

Step 12: Take the upper layer of both sides and fold the lower parts into the center like you see in the picture.

Step 13: Turn the paper over and do the same thing to the other side.

Step 14: Take the right flap and fold it over to the left.

Step 15: Flip the whole piece over and do the same to the other side (folding the right flap over to the left).

Step 16: Take the bottom flap and fold it over to the top like you see in the picture.

Step 17: Flip the paper over and do the same thing to the other side.

Step 18: Take the top layer of the right flap and fold it over to the left.

Step 19: Flip it over and do the same thing to the other side (folding the right flap over to the left). Both sides should look like this now. Step 20: Just like you see in the picture diagram, take the left and right pieces underneath the top flap and pull them apart. Crease the bottom of those pieces so that they'll stay spread apart.

Step 21: Take one of those pieces that you pulled apart, and slightly open the top corner so that you can bend a portion of it down to form the head. Crease the sides of the head up so the piece will stay bent

ORIGAMI BUTTERFLY 1

Step 1: Start with a regular piece of rectangle paper. An 8.5x11 paper is fine.

2

Step 2: Fold the paper in half by folding the upper left corner to the lower right corner. Unfold

3

Step 3: Repeat Step 2 with the other corner. Unfold

4

Step 4: Fold in half again by folding the top half back. Unfold

5

Step 5: With your finger, push down on the middle so that it pops in.

6

Step 6: Bring the left and right creases together to form this triangle

7

Step 7: Fold the left corner of the top layer to the top corner of the triangle.

8

Step 8: Fold the right corner to the top corner. Turn over.

9

Step 9: Fold the bottom part of the triangle up with a portion of the top corner showing, like in the picture. Turn over.

10

Step 10: Pull down the left flap of the triangle and the side will be forced to bend in. Fold and flatten the side down.

11

Step 11: Like before, pull down the right flap and fold in the side. Turn over.

Step 12: Fold down the top triangle.

Step 13: Fold a good portion of the triangle back up, but leave some parts folded down.

Step 14: Mountain fold in half. In other words, fold the left side under the right side.

Step 15: Diagonally fold the wing as shown.

Step 16: Turn over

ORIGAMI RABBIT 1

1. Fold the top corner down to the bottom and make a nice precise crease.

2

2. Fold both the top left and top right corners down to the bottom point and crease well.

3

3. Fold the left and right corners up to the top point, again creasing well.

4

4. Start with the right flap, open it out to the right, pressing the top of it down to form a slanted triangle. Repeat on the left side.

5

5. Rotate the paper to the left a little. Fold the top section backward and behind.

6

6. Take the flap which is at the bottom right, and flip it up and behind. This is a rotation movement, not a reverse fold. Repeat on the flap on the back.

7

7. Now fold the ears over to the left as indicated, the ears don't have to all be the same, as it's an animal, it looks nicer with some asymmetrical folds.

8

8. Hold onto the ears at the 'head'. Open out the left sections, the nose should godownwards, while the left flaps are pushed over the top of the ears on both the front and back of the rabbit.

9

10. Fold the nose under. This is now complete but I like to fold the ears back out a little. I also like to glue the flaps that stick out from the neck, depending on what type of paper you use.

10

Now your origami bunny is complete!

11

I hope it worked out well for you, if not, give it another go, sometimes it can take a few attempts to get it right.