Final 1

Take Assessment - Final Exam - CCNA 1 Networking Basics (Version 3.1) 1 Which cable specifications are indicated by 100BASE-T? 100-Mbps transmission speed, baseband signal, coaxial cable 100-Mbps transmission speed, broadband signal, twisted-pair cable 100-Mbps transmission speed, baseband signal, twisted-pair cable Equal to 10-Gbps transmission speed, baseband signal, twisted-pair cable 2 Which LAN switching mode has the highest latency? fast forward fragment-free latency forwarding store-and-forward 3 Which of the following must be present for current to flow? (Choose three.) closed loop bit-generating device insulating material source of voltage load switch 4 Which of the following is the binary representation of the decimal number 111? 01101111 01111101 11110111 11101101 5 Which of the following describes a physical full-mesh topology? It requires termination at both ends of the cable. It uses a hub or a switch as a central point to connect all wires. It provides maximum connectivity between all network systems. It links all computers to a main computer that controls all traffic on the network. 6 What is attenuation? opposition to the flow of current measurement of electrical signals relative to time degradation of a signal as it travels along the medium amount or volume of traffic that is flowing on the medium 7 Determine the number of useable networks and hosts for the IP address 192.168.50.0/27 4 networks / 62 hosts

6 networks / 64 hosts 32 networks / 8 hosts 6 networks / 30 hosts 8 networks / 32 hosts 2 networks / 8 hosts 8.

Which cable diagram displays the end to end pinout for a crossover cable used with Cisco devices? Cable A Cable B Cable C Cable D 9 Which of the following describe the token-passing logical topology? (Choose two.) FDDI is an example of a token-passing network. Token-passing logical topologies must also be physical ring topologies. One of the disadvantages of the token-passing logical topology is the high collision rate. Computers transmit data after "listening" to the wire to detect other traffic. Computers are allowed to transmit data only when they possess a token. 10 Which of the following commands could be used on a Windows-based computer to view the current IP configuration of the system? (Choose two.) configip ifconfig ipconfig winipcfg winipconfig 11 How is data encapsulated as it is moved down the OSI model? data, segments, frames, packets, bits data, packets, segments, frames, bits data, segments, packets, frames, bits data, packets, frames, segments, bits

12 Which of the following are characteristics of IP? (Choose three.) connection-oriented protocol connectionless protocol reliable protocol unreliable protocol routed protocol routing protocol 13 Which of the following devices extend a collision domain? (Choose two.) switch hub bridge router repeater 14 How is full-duplex capability typically achieved in fiber-optic cable? Two fibers are encased in separate sheaths. Light is bounced at different rates in opposite directions. Transmit speeds are so high that half-duplex is acceptable. Colors of the light spectrum are separated into transmit and receive streams. 15 Which of the following is the decimal representation of the binary number 11010011? 203 204 211 212 16 What is verified by the ping 127.0.0.1 command? the TCP/IP network configuration and is called an internal loopback test connection to the remote host with the IP address 127.0.0.1 whether the router that connects the local network to other networks can be reached the route packets take between the local host and the host with the IP address 127.0.0.1 17 When using Category 5 UTP cable, which RJ-45 pin pairs are used to exchange data between hosts on an Ethernet network? 1 and 2; 4 and 5 1 and 2; 3 and 6 3 and 6; 7 and 8 4 and 5; 7 and 8 18

Which one of the router connectors shown in the graphic would be used for a LAN connection? Connector A Connector B Connector C Connector D 19 Which of the following increases the potential for a collision to occur? the use of an active hub instead of an intelligent hub the use of an intelligent hub instead of an active hub a reduction in the number of devices attached to the hub an increase in the number of devices attached to the hub 20

How many collision domains are shown in the diagram? three four five six seven eight

21 Which of the following networking devices divide a network into separate collision domains? (Choose two.) repeater bridge switch AUI hub 22 Which of the following statements are correct about CSMA/CD? (Choose three.) It is a media access method used in LANs. It is a media access method used in FDDI WANs. When a device needs to transmit, it checks to see if the media is available. A device sends data without checking media availability because all devices have equal access. Multiple devices can successfully transmit simultaneously. Only one device can successfully transmit at a time. 23

Examine the graphic with current configurations. The New York Offices of ABC Company recently upgraded the computers in the administrative office. Shortly after the upgrade, Host A in the clerical office failed and was replaced with one of the retired administrative office computers. However, the computer can not access the company network in the new location. What is the likely cause of this network access issue for Host A? MAC address incorrectly entered default gateway incorrectly entered subnet mask incorrectly entered IP address incorrectly entered 24 Which of the following are transport layer protocols of the TCP/IP model? (Choose two.)

FTP UDP SMTP TFTP TCP 25

What information can be determined from the MAC addresses of PC1, PC2, and PC3, as shown in the graphic? (Choose two.) PC1 and PC2 NICs need to be replaced because they have the same OUI identifier. PC2 and PC3 NICs need to be replaced because they have different OUI identifiers. PC1 and PC2 NICs are from the same vendor. PC1 and PC3 NICs need to be replaced because they have the same vendor-assigned address. PC2 and PC3 NICs are from different vendors. PC2 and PC3 NICs are from the same vendor. 26 A network administrator is placing an older router back in to service. The administrator discovered that the IOS (internet operation system ) and configuration files need to be updated to meet the LAN specifications. Which application layer protocol is used to transfer the new configuration files into the router memory? SNMP SMTP HTTP TFTP 27 Router interface Ethernet 0 has been assigned the IP address 10.172.192.168 255.255.255.240. What is the address of the subnet to which this address belongs? 10.0.0.0 10.172.0.0 10.172.192.0 10.172.192.160 10.172.192.168 10.172.192.175 28 Which of the following best describes Spanning Tree Protocol? It enables a network to span across multiple physical segments. It enables a switch to eliminate switching loops. It enables a switch to dynamically choose the best switch mode. It enables a switch to perform as a router.

29 Which type of UTP network cable connects two Cisco switches? straight-through crossover rollover patch 30 Which of the following subnet masks could be used when subnetting a Class B IP address? (Choose two.) 255.0.0.0 255.255.0.0 255.192.255.0 255.224.0.0 255.255.252.0 255.255.255.128 31

Refer to the graphic. What must be configured on Host A to allow it communicate with the e-mail server? (Choose three.) 0 IP address subnet mask default gateway router name switch name NetBIOS name address 32

How many broadcast domains are shown in the diagram? three four five six seven eight 33 Which type of address is 192.168.17.134/29? host address network address broadcast address multicast address 34 Which of the following networking devices increase the number of collision domains? (Choose three.) switch hub bridge router repeater 35 Which type of address is 192.168.17.111/28? host address network address broadcast address multicast address 36 Which LAN switching mode begins switching after reading only the first 64 bytes of the frame? fast forward fragment-free latency forwarding

store-and-forward 37 What is the maximum length of a media segment used for 100BASE-TX? 100 meters 185 meters 400 meters 500 meters 38 Which of the following describes latency? the noise generated from outside a cable the degradation of a signal as it travels along the media the time required for a NIC to place a frame on the network media the delay between the time a frame leaves its source device and reaches its destination 39 Which of the following are advantages of UTP cable installation? (Choose three.) less expensive than fiber optic media flexible and easy to install in a building must change termination connection points when upgrading hardware considered the fastest copper-based media receives less RFI and EMI interference than fiber optic media allows for easy WAN hardware upgrades 40 Which of the following OSI layers offers reliable, connection-oriented data communication services? application presentation session transport network 41 How does network cable length affect attenuation? Category 5 cable that is run in metal conduit has the highest attenuation in the shortest distance. Shorter cable lengths have greater signal attenuation. Longer cable lengths have greater signal attenuation. The length of the cable has no effect on signal attenuation. 42 Which type of cable is required to make a connection between a router console port and a PC COM port? straight-through cable crossover cable rollover cable DB-9 cable coaxial cable

43 Which of the following are considered WAN technologies? (Choose two.) DSL Ethernet Wireless Ethernet T1-Carrier Token Ring 44

Based on the graphic above, which of the following occurs as each host system comes on line in the topology? The switch sends its MAC address to each host. The switch adds MAC address to the bridge table as each host sends a frame. Each host exchanges MAC addresses with each other. The switch listens for data traffic to block since the switch lacks an IP address. 45 Two peer hosts are running applications that exchange data using UDP. During the current session, a datagram fails to arrive at the destination. What is true concerning the retransmission of the datagram? Datagram retransmission occurs when the retransmission timer expires in the source host. Datagram retransmission occurs when the retransmission timer expires in the destination host. Datagram retransmission is controlled by the application layer protocol. Datagram retransmission involves only the data with sequence numbers equal to or higher than the sequence number of the current datagram. 46 Which two statements describe the TFTP protocol? (Choose two.) uses authenticated file transfer procedure provides connection-oriented service provides connectionless service provides more features that FTP lacks most of the features of FTP 47 Which of the following describes the RIP version 1 routing protocol? Cisco proprietary hybrid protocol

distance vector protocol that uses hop count as the only metric link state protocol supporting multiple routed protocols distance vector protocol that uses delay, bandwidth, load, and reliability metrics 48

Which devices shown in the graphic must have a MAC address? only PC only router PC and router PC, hub, and router PC, printer, and router 49

How will the MAIN router dynamically learn a route to the 10.16.10.48/28 subnetwork in the diagram? with a routed protocol with a routing protocol with a static route with a directly connected route 50

What kind of connection is represented in the graphic? console connection Ethernet connection ISDN connection leased line connection 51 When is a straight-through cable used in a network? when connecting a router through the console port when connecting one switch to another switch when connecting a host to a switch when connecting a router to another router : rollover 52 When is a crossover cable used in a network? when connecting a host to the router console port : rollover when connecting a host to a switch when connecting a host to a host when connecting a switch to a router 53 Examine the graphic with current configurations. Host A in the Clerical offices failed and was replaced. Although a ping to 127.0.0.1 was successful, the replacement computer can not access the company network. What is the likely cause of the problem? IP address incorrectly entered network cables unplugged subnet mask incorrectly entered network card failure 54 Which of the following application layer protocols use UDP segments? (Choose two.) DNS FTP Telnet TFTP SMTP

55 Which of the following are characteristics of UTP cable? (Choose three.) Each wire is covered by insulating material. It is not affected by EMI or RFI. It is a four-pair wire medium. It is difficult to terminate the cable. It relies on the cancellation effect produced by the twisted wire pairs. It is more expensive than any other type of LAN cabling.