Configure physical network connections Perform the following steps to configure the physical network connections. 1 Perform the following: The Network Connections window is displayed. 2 Right-click the A - Yellow network connection and choose Properties. The User Account Control dialog box is displayed. 3 Click Continue. The Yellow Adapter Properties dialog box is displayed. 4 In the Networking tab, select Configure. 5 Perform the following steps in the Advanced tab and Link Speed tab, depending upon your adapter. • Broadcom adapter — Advanced tab – IPv4 Checksum Offload and ensure the value is set to Rx & Tx Enabled. – Jumbo MTU and verify/change the value to 1500. – Large Send Offload v2 (IPv4) and verify/change the value to Disabled. – Receive Side Scaling verify/change the value to Disabled. – Link Speed & Duplex and verify/change the value to 100Mb full. • Intel adapter — Advanced tab – Jumbo Packet verify/change the value to Disabled. – Large Send Offload (IPv4) verify/change the value to Disabled. – Large Send Offload (IPv6) verify/change the value to Disabled. – Receive Side Scaling verify/change the value to Disabled. • Intel adapter — Link Speed tab – Link Speed Tab and verify/change the value to 100Mbps/Full Duplex. 7 CONFIGURE FTE
70 www.